Overview
This article explains how to configure and use CODEGRIP for programming a target MCU over a WiFi network. This feature is optional and requires a WiFi license.
Instructions
1. WiFi Mode Setup
- Connect the CODEGRIP device to your computer using a USB cable for the initial setup.
- Open the CODEGRIP menu and select the Configuration menu item.
- Navigate to the WiFi General tab:
- Enable WiFi from the Interface State drop-down menu.
- Set the Antenna Type to match your hardware setup.
- Choose Station Mode from the WiFi Mode drop-down menu.
2. WiFi Network Setup
- Go to the WiFi Mode tab and configure the following:
- SSID: Enter your WiFi network name.
- Password: Enter the password for your WiFi network.
-
Security Type: Select the appropriate security type:
- Open
- WEP
- WPA/WPA2
- Click the STORE CONFIGURATION button.
- A pop-up will notify you that the CODEGRIP device will restart. Click OK to proceed.
3. Connect to CODEGRIP Over WiFi
- After the restart, wait for the ACTIVITY LED to stop blinking, indicating that the device is ready.
- Open the CODEGRIP menu and select the Scanning menu item.
- Click SCAN DEVICES to list available CODEGRIP devices.
- Locate your CODEGRIP device by its serial number (printed on the bottom of the device) and click the WiFi Link button.
- The WiFi Link indicator will turn yellow upon a successful connection.