Start a conversation

USB Communication Error with mikroProg for STM32

If you get an error when you try and program using our mikroProg for STM32, then this is a workaround.

When you open the mikroProg Suite for ARM, do the following:

1. Disconnect the mikroProg from your PC;

2. Reconnect it;

3. Click on Options;

4. Select JTAG(even if it is selected already, click on it again);

5. Click OK;

6. Program.

Choose files or drag and drop files
Was this article helpful?
  1. Strahinja Jacimovic

  2. Posted



    Hey. Can you tell me how can I use IF on the program? Well I have to do when I click the switch the program must start and when I click again it must turn off. I tried to use *BUTTON == 1* but it gives me an error telling that *1* can’t put.


    Does not work. the mikroprog says "Your Frimware is not up to date, do you want to upgrade your firmware?"

  3. 박중현

    Error occurred on board porg in mikromedia7 for STM32F4. what should I do?